How To Measure Toilet Rough In Without Removing Toilet

Once you are done with the measurement, turn off your water supply and flush the toilet to empty its tank. Use your tape measure to determine the distance from the wall behind the toilet to the center of one of the closet bolts.

Danze Parma D316658T Widespread Bathroom Faucet

Mark out your desired grid pattern on the floor, and lay tile over the unobstructed areas.

How to measure toilet rough in without removing toilet. Removing the old toilet and measuring the footprint on the floor will give you a more exact measurement. The toilet was squeezed in when we took it out. If the toilet is still in place, the center of the flange should align with the rear bolts that keep the toilet attached to the floor.

As there are different sizes, there is generally 3 or 4 drain for toilet. Remember, the center of the toilet flange to the wall should be 12 inches. The toilet seat itself spans 18.5 inches long and is just under 14 inches at its widest.

1 place the end of a tape measure against the wall behind the existing toilet, not on the molding at. The closet bolts are the bolts holding your toilet to the floor. Now that we've added tile to the wall it will not fit.

Start by measuring from the wall behind the toilet to the center of the bolts at the base of the toilet. Tank pressing against the wall. Then, cut a few sheets of paper that match the size of your tile so you can use them to make your measurements.

Usually, the distance is 12 inches, so a standard toilet will fit just fine in this space. If you have two closet bolts on each side, measure to the center of the rear bolt. Oversize toilets may not fit in this area however.

If you need to cut 1 tile to go around the flange, cut 1 sheet of paper; If you need 4 tiles, cut 4 sheets of paper. Remember not to include the baseboard thickness in your measurement.

Pictures sure would make all this easier. Best toilet for 13.5 inch rough in toilet replacement. We feel that a 10 rough in toilet would solve the problem, but before we.

Most rough openings are 12 inches, but can be as little as 10 inches and as much as 14 inches. The seat itself is 16.5 inches above the finished floor. For most toilets this distance is 12 inches.

Before purchasing your new toilet, measure the distance from the rearmost bowl holddown bolts to the finished wall behind the toilet. You new toilet must match your old toilet's rough in. Dry the remainder with a sponge.

If your existing toilet has four bolts, measure to the center of the back bolts. Hold the trip lever down so that all the water runs out; If there are four bolt caps, measure to the rear set of bolt caps.

If your rough in is a different size, ask your local toilet store for assistance. Use your tape measure to determine the distance from the wall behind the toilet to the center of one of the closet bolts. If measuring for a replacement toilet, just measure from the back wall to the center of the toilet drain and write down the measurement.

American Standard Cadet Tall Height 10 in. RoughIn 2